tangency

英

美

网络  切线连续; 接触; 相切; 切向参考; 切矢连续

复数：tangencies　

英英释义

noun

• (electronics) a junction where things (as two electrical conductors) touch or are in physical contact
  1. they forget to solder the contacts
  Synonym:contact
• the state of being tangent

双语例句

• The paper deals with two types of connection of developable surfaces, namely intersection and tangency.
  探讨了可展面连接的两种类型：相交连接与相切连接。
• Now, he's using a much longer sample than I did, so he's not going to get this tangency portfolio that I did.
  他的样本跨度比我的要大多了，所以他得出的切线资产组合会和我的不同。
• The optimal allocation of the certainty and severity of penalty under the cost restrain is the point of tangency of the curve of equal deterrence and the curve of equal cost of deterrence.
  成本约束下的刑罚确定性与严厉性的最优配置是等威慑水平曲线与等威慑支出曲线的切点。
• Concepts about bridge node and loop tangency are proposed. The principle of the loop shrinkage of the signal flow graphs is deduced from the point of view of the equivalence of node split.
  提出了桥结点、环路相切概念，从结点分裂的等价观点出发，导出了信号流图中环路收缩的原理。
• This is just as point of tangency of this dissertation.
  这正是本研究的切入点。
• The tangency portfolio is the portfolio that one should hold.
  切点投资组合就是我们应该持有的投资组合。
• Somebody else might say, well I want to just hold this point, I want to hold the tangency portfolio.
  而另外的某些人可能会说，我就想按这个点的比例来持有投资，我想持有切线投资组合。
• The exterior tangency points P1 and P4 mark the coordinates where the penumbral shadow first contacts ( partial eclipse begins) and last contacts ( partial eclipse ends) Earth's surface.
  表面接触点P1和P4所处的坐标位置为第一次接触半影区和最后一次接触。
• The essence of arc joining is making the tangency of the arc and line or the arc and arc. The programmed Drawing method of arc joining based on AutoCAD secondary-development is studied in this article. The Visual LISP drawing program of arc joining is merited.
  圆弧连接的本质就是使圆弧与直线或圆弧与圆弧相切，在此研究了基于AutoCAD二次开发的圆弧连接程序化绘制方法，用VISUALLISP语言编程建立了圆弧连接通用绘图程序。
• Given a NURBS curve, perturbation for control points is chosen and the LSM ( Least Square Method) is used to modify the geometric features such as position, tangency or curvature of the selected parametric point on the given curve.
  通过对NURBS曲线的控制顶点扰动，采用最小二乘法修改曲线上给定一点处的位置、切矢和曲率等几何特征，并讨论了多点几何特征同时修改的情况。